Home

  LarryB's startercontacts.com        

Starter contacts for Nippon Denso starters. on Dodge, Chrysler, Plymouth, Honda, Subaru, Geo, Toyota, Lexus & many others.

LarryB's  solenoid contact install instructions.

• Disconnect battery cables.
• Disconnect cable and starter wire from starter and remove starter.
• Disconnect starter cable from solenoid as shown.

• remove three solenoid cover screws, cover,  and plunger. Make sure not to loose the spring or ball (sometimes the ball stays in the hole, but watch for it).

• Remove exterior nuts from contact lugs.

• Reinstall New Contacts and new plunger. Slide the rubber o-rings on the bolts after the plastic guard goes on. The longer bolt has serrations and will pull into the new contact when you tighten the bolt.

• Make sure new contacts are resting flat against back of contact chamber.

• Reassemble and reinstall.

• <<< Back to order page

If you have comments or questions, email me at this address->  larrybuckinc@gmail.com